Machsupport Forum
Third party software and hardware support forums. => LazyTurn => Topic started by: stevep on March 30, 2010, 07:00:28 AM
-
Hi everyone
I am new to mach 3. I am trying to use Lazy turn to generate Gcode to run a lathe. I can inport a GXF file select tool, generate a roughing cuts, finishing cut etc. but can not generate a G code listing at the end. when I select "post" a file is created but the file is blank. Please can someone tell me what I am doing wrong.
Steve
-
Steve,
GXF? you mean DXF...
Do you have the latest / free version of LazyTurn installed? see the manual for instructions located in Members Docs as it was updated / Rev 7
Section 4.5
Posting code- Section 5.16
Post the DXF file and i will take a look at it .
RICH
-
Sorry, but could some direct me to the "Members Docs for LazyTurn" I have now idea where to find this
Thanks,
Jeff E.
-
HERE IS THE LINK
http://www.machsupport.com/forum/index.php/topic,10091.msg62041.html#msg62041
RICH