Machsupport Forum
Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: cro24 on March 26, 2010, 10:35:02 PM
-
How about I'm new in this forum, and I wonder if you can help me, I'm investigating the ways to create the Wizard to the Mach3, how can I create it by myself, also those that already brings the Mach3..
Thanks
-
Writing a wizard requires doing a screen design and writing some VB code. I suggest you first look at the videos on this site. They are a bit old, but mostly still accurate. There is also a lot of good info in the wiki, also on this site..
-
Thanks for the reply, but I need more information and more specific as i was checking the VB codes but they found many, what is the right choice.
I hope and can help me as soon as possible.