Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: jlautomatio on October 04, 2006, 10:01:11 AM
-
need info on new upload
my problem is when i generate g code with lazycam it generate like this
c:\mach3\gcodef09.nc
it should be
c:\mach3\gcode\f09.nc
-
Okay that will be done next week after i get back from the trip :)
-
hi find some think it look like if i generate the gcode and change the directory it mist the \
thank you
-
hi brian
soon you fix the problem let me know and put on ftp
thank you
jacques
-
allo brian
not fiend the problem on lazycam
thank you
jacques
-
There is work being done on it now :)
-
Don't know what to tell you.. I can get it to break ???
Could you post the file and your XML?
Thanks
Brian
-
this 2 file the original and after
the original it ok save at c:\mach3\gcode\
and after i change dir like C:\mach3\gcode\demo
it mist the \ after demo and save like this c:\mach3\gcode demof34.nc
so the file is demof34.nc it should be in file c:\mach3\gcode\demo\ and name f34.nc
you gone to find in the xml file after place to save it mist the \ after c:\mach3\gcode\demo <-----------
thank you
Jacques
-
sory this is the one after i change dir
thank you
jacques
-
hello
still not find the problem about the \ missing
thank you
jacques
-
I will test it in the next few days now that I have your XML
Thanks
Brian
-
allo Brian
on lazcam 2.66 still missing the \ when we change in gcode file options it lose the \
thank you
-
I have tested for that and I can't get it to post wrong :( there is something that we are missing and at some point it is going to show up!
Any one have this happen?
-
Hi, Jlautomatio & Brian
If Mach3 & LC reside in other than Mach3 folder, like Mach3R2.0.010.
The Gcode post's to Mach3R2.0.010\ gcodetest55Dotpolyline.tap, rather than Mach3R2.0.010\gcode\test55Dotpolyline.tap.
Need's a back-slash gcode " \" test55Dotpolyline.tap is missing.
Thank's Chip
-
Okay that is two of you with the same problem :( I still can't get it to happen here! That makes it very hard to fix... I think that I will have to recode that section and see if i fix it by luck..
-
this is small video to see the problem
-
hi Brian
???????
on ver 2.66 you change------------ layer control---------------- for ------------auto clean setting -------------------?????
how we put all the inf we use to put on layer control it was easy on the first one
thank you jacques
-
you can change the settings at the bottom of the screen :) There should be a video showing how to do this...
Take a look at the video and if you have any problems or questions I am here
thanks
Brian