Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chad on October 03, 2006, 07:29:25 PM
-
Just thought I would relate a little story about what happened today.
I have a converted Bridgeport style mill with a g100. I had been holding off on updating mach and the plug in because things were mostly working and I have some stuff to get done by this weekend. I was having a problem with mach and the g100 just stopping mid job. I know art has been working on this and it was probably time to update.
I updated to the latest 2.0g and the latest g100 plug in. I loaded gcode and did a dry cut and the thing would hang just after start, no jog no Nada. Not good.
I sent a couple of panicked emails to art and an hour later I had a new g100 plug in and have been cutting without problems sense.
Art and the artsoft team offer astonishing customer service, especially for the price.
Thanks!
Chad
-
I will make sure Art and Brian sees this.
-
Thank you! 8)