Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ChandlerW on March 20, 2010, 11:52:12 AM

Title: Toolpath (stock) in Mach3Turn is monster sized
Post by: ChandlerW on March 20, 2010, 11:52:12 AM

Quick question for a subject that I couldn't find in a search of the website.
I use Mach3 mill but just started getting into Mach3Turn. The image that represents the bar stock in the toolpath window is monster sized. I'm working with something that is .310 in diameter and it looks like a little stub on the end of the bar stock.
There is a setting Config->Toolpath->Stock Size that is set at 20 and is greyed out.
I'm using a demo version of Mach3.

Title: Re: Toolpath (stock) in Mach3Turn is monster sized
Post by: Hood on March 20, 2010, 01:12:02 PM

Toolpath in turn can be a PITA at times, this should be sorted in Rev4 of Mach.
Hood