Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: williamwoodworker on March 17, 2010, 03:12:28 PM

Title: No Keyboard response
Post by: williamwoodworker on March 17, 2010, 03:12:28 PM

Environment - K2CNC model KG9850R, Acer Computer running Vista (don't get me started on that), Mach 3 software version R3.037

We had to move our CNC setup recently, and now that it has been all reconnected, there is no response to the arrow keys page up/down. Mach 3 sees the keyboard and responds to shor cut keys. When we load and run G-Code the machine responds correctly. But pressing the arrow left/right/up/down or page up/down keys does not cause the head to move. This set up was working fine prior to the move. We have tried rebooting the computer, restarting the controller, changing keyboards, all to no avail. Any Ideas?

Thanks for your time.

Title: Re: No Keyboard response
Post by: Hood on March 17, 2010, 03:22:00 PM

Jog control turned off is the most likely reason.
Hood

Title: Re: No Keyboard response
Post by: williamwoodworker on March 18, 2010, 09:42:32 AM

That was it. Many Thanks.

Title: Re: No Keyboard response
Post by: Hood on March 18, 2010, 10:45:41 AM

No problem :)
Hood