Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: JDolecki on October 01, 2006, 08:00:20 PM
-
After many long nites in the garage i finally have movement. ( IT'S ALIVE) While i have a coulpe of small problems to deal with my question is, How do you control the feed speed? I read the manual several times but im just not getting it. Is it in the tool table or am i missing something.
-
Hi, JDolecki
On Program Run screen Clock on F window set there enter key after + - Reset.
TAB key, screen jog keys and other item's
Gcode, G01 x1 y1 F25 the f sets the speed.
Hope this Helps, Chip
-
You have every right to have a tear. Its a terrific feeling when you finally see this thing you have been working on for so long, actually work.
Good job.