Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: CNCdn on March 12, 2010, 12:35:05 PM
-
Obviously, I'm missing something ???
I can't seem to figure out how to save all my settings (motor pin allocations, limit switch conditions, motor tuning etc).
I choose "save settings" but when I try to "restore settings" and the program shuts down and I re-start it by opening "MyMill" file, I must re-set all parameters.
There's a trick here but I can't seem to find it. :-\
A little help please.
Alex
-
Change your settings then shut Mach down and restart and they should be saved. If they are not then it would seem your xml is set as read only.
Hood
-
Thanks Hood.
Don't know what I WAS doing but it obviously wasn't that because I did EXACTLY that and everything WAS saved. ::)
Thanks for your help.
Alex
-
LOL no probs.
Hood