Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dgalaxy on October 01, 2006, 04:26:02 PM
-
when i load the gcode in mach 2 thc3000 all i see is a bunch of circles. if i dont not use a the thc files and just run regular mach2 mill or mach 3 i can see the tool path just fine is the a setting i have to adust or something this is really weird
John
-
it sound as is you have absolute I & J set when you should have it incremental, check this on the settings
Graham.
-
you are exactly right that fixed the problem thank you so much
John