Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: james elder on March 10, 2010, 07:42:35 AM
-
Hello Guys.
I have moved premises, and it involved taking the machine to pieces.
I have missed something out in the reassembly, because I can't get the machine to 'energize'. Normally as Mach3 starts up there is a click from all the steppers, and we have power. I am not getting that, or any lights on the Geckos, although there are one or two on the circuit board. Mach3 and PC seem fine, just not the machine.
What should I look for?
Jim
-
Just have to check the wiring and make sure everything is connected properly, maybe also check that the port is seated properly if it is a PCI port you are using.
Hood
-
Will do
jim
-
Well.
I looked in the plug ??? and it wasn't that, it was the next wire i looked at. I can't believe it. Spade connector off my copper donut.
How do you guys do it? It's some kind of voodoo isn't it guys? 34 reads, you each send out some kind of vibe...there's the problem solved This forum is the greatest. here's some back~~~~~~ Jim
-
LOL