Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mdash on September 28, 2006, 10:30:39 PM
-
I would like to use Mach to control a serial io card I made. However I can find very little about how to use the event driven serial control. I did find a few posts about using fifo. Is there somewhere that I can find more details?
-
I think the best thing to do is to look at the Plug In for the G100 and have a look at how the data is passed to it. THere is a Doc that Art did that tell how it works :) It is all on the downloads page.
Thanks
Brian