Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kencor1 on February 24, 2010, 02:22:08 PM
-
I just updated to the newest lockdown version of Mach. When I am running a program and hit feed hold then move the axis's from the current position, then when I hit cycle start again I am no longer getting the screen that usually would pop up before the axis move back to the position in the program. I looked and I don't know what setting I am looking for, or if this is a bug.
Thanks
Tom
-
Tom after a feed hold that is the correct operation.
You are thinking of RUN FROM HERE where you are asked for a preparation-al move
If YOU turned off the spindle when you used the feed hold, don't forget to TURN IT ON
Phil
-
Thanks, Phil... But in the old version a screen would pop up giving the XYZ coordinates and then the was a box to enter a rapid to position z Height and there was a check box to start the spindle.
Thanks Again,
Tom
-
Afraid I never do that as I always press run from here if I move away after a feedhold. I just tried simulating in the version I have loaded here and it didnt ask for a prep move to OK.
What version were you using previously?
Hood
-
The Version that it worked in was 3.041. The window that would pop up has a title of Position preparation at the top.
Thanks,
Tom
-
Here is a screen shot of the box
-
Yes I know what the prep move is but I am glad you posted the screenshot as I see SmoothStepper in your profile. What Rev of SS plugin are you using and also after the feedhold are you pressing Stop so you can jog?
Hood
-
Just loaded 3.041 and yes I get the prep move box, not sure when it stopped doing that as I never use it but I will try different revisions and see if I can find the one it stopped with.
I am thinking however it may have been changed deliberately as the proper procedure would really be a Run From Here, but thats just a guess ;D
Will see if Brian can shed any light on it.
Hood
-
After pressing feed hold I jog an axis away from the current position, then when I press start again the prep move screen pops up. The version of smooth stepper in the most current one. I have it installed in the old Mach and the new.
Thanks,
Tom