Machsupport Forum

Mach Discussion => Mach Screens => Machscreen Screen Designer => Topic started by: Finnepinnen on February 15, 2010, 08:29:39 PM

Title: 1:1 pixel mapping
Post by: Finnepinnen on February 15, 2010, 08:29:39 PM

Hello

I'm quite new to Mach3 but I've desided to make myselfe a new screen.
I installed the MachScreen editor and so far so good.
Then when I tried my screens they wouldn't appear pixel mapped. Depending on the
windows size when I load the screen it shows about 34 pixels lower on the height and somewhat
40 pixels on the width. This behaviuor makes the screen go smudgy and unclear.
Is there a way or a workaround to get the screens 1:1 pixel mapped?

Hope you understand, I attached two pictures aswell!
Note the patterned line.

Best Regards
Peter Eriksson

Title: Re: 1:1 pixel mapping
Post by: Klaus1311 on February 16, 2010, 06:46:57 PM

Hi Peter,

can you send me your set-file? You can find my email address in Machscreen under help->email.


Klaus