Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Curmudgeon on February 14, 2010, 08:20:28 PM
-
I have Mach3 set up in inches.
My steppers are 200 steps per 1 rpm
My microstepping is at 8, so I have 8 * 200 = 1600 actual steps per rpm
I have 1/4 - 20 lead screws, so I have 20/rpms per inch
so 20rpm/inch * 1600 steps/rpm = 32,000 steps per inch
This gives me 32000 "steps per" in the motor config setting correct ?
-
Yes, that's correct.