Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: jonny quest on February 10, 2010, 01:07:38 PM
-
http://www.madcamcnc.com/start_page.html
This is the set-up I think I'm going to end up with for my 5 axis build.
I have a microscribe digitising arm, Rhino4.. now just need to purchase this Madcam. I had the demo but let it expire before really getting to play with it because I was learning Rhino and the Microscribe.
It's a 3+2 right now... but rumors of full simultaneous 5axis is very soon. Maybe even within a couple of months.
There's a guy on CNCzone that uses this in a production machine shop and he says this is almost comparable to his $20k programs!