Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: cncbailey on January 14, 2006, 08:13:01 PM

Title: computer overscans page
Post by: cncbailey on January 14, 2006, 08:13:01 PM

I have a laptop that does not drive the cnc very well, but presents the entire opening screen Mach3 in a satisfactory manner.  (XP home)
I have a desktop that tests well on the waveshape tester, but over scans the opening screen to present only 80% of the screen. The right hand side is unusable and the bottom is unuable.  ie. I cannnot see "reset" etc.  This computer is running XPro.

Any suggestions?

thanks

cncbailey

Title: Re: computer overscans page
Post by: Brian Barker on January 14, 2006, 09:10:48 PM

On the desk top can you set the screen to 1024 X 768?

There is also a setting under Config/State Auto Screen Enlage please see that this is ckecked.

As for the labtop I don't think it is goingt to work...