Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Monty on February 08, 2010, 12:36:07 PM
-
This pertains to mach3turn.
I've selected the auto tool changer option in the general config. but for some reason when I call for a tool change it still requires a cycle start to continue.
What gives ???
The one good thing is since my chip control is not totally dialed in yet, it gives me a chance to remove the birds nest from the boring bar ;D
Monty
-
What do you have in your macro? Make sure there is nothing in the m6end.m1s.
Hood
-
Thanks Hood,
I'll check.
Monty
-
Well no joy. M6end is completely empty. It still waits for cycle start.
Monty
-
Don't have an M1 in there do ya ? And "Stop on M1 Command "checked ?
Just a shot,
RC
-
What do you have in your M6Start macro?
Hood