Machsupport Forum

Third party software and hardware support forums. => Galil => Topic started by: Cncman2nv on February 04, 2010, 11:54:22 AM

Title: no X axis JOG after Homing
Post by: Cncman2nv on February 04, 2010, 11:54:22 AM

I have a bridge port eztrak i have been upgrading and after homing in all 3 axis with the soft limit button active the x axis wont jog but he others will
the setup Iam currently using is one switch on each axis used for homing no limits also Iam Using the current galil plug-in 4.4.0.0