Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: artecnc on February 04, 2010, 10:56:44 AM

Title: Alphacam
Post by: artecnc on February 04, 2010, 10:56:44 AM

Hi
I read that I can use Fanuc post, when y load the file in the Mach3, dont see a toolpath¿?...is that correct? I´m used to Syil 4Plus Mill.
Thank in advance
Antonio

Title: Re: Alphacam
Post by: stirling on February 04, 2010, 12:14:20 PM

artecnc (Hmmmmm... interesting user name)

You should see the toolpath IF Mach is able to interpret it successfully. Otherwise you'll see no toolpath and Mach will report the (first) error on the Status: line (bottom left of screen)

Ian

Title: Re: Alphacam
Post by: artecnc on February 04, 2010, 03:24:25 PM

Thank you very much
I wiil see that...and you can see my site
 www.artecnc.com.ar...and now I began to do some parts for rc model cars.
Best regards
Antonio