Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: swets on September 23, 2006, 05:37:52 PM
-
Hello,...
Maybe crazy, but i never see a 6 axis machine... ???
I haveĀ build a machine with 3 axis...
is a 6 axis also possible to build ?
is there a page on internet about 6 axis,
or a image?
-
Not sure what 6 axis is but, here is a link to a site that sells a head that converts a 3 axis to 5. Check this out http://www.5-axis.com/
-
I have converted a 6 axis machine, it was a Walter Tool and cutter grinder (see attached), worst part for me was that it was the first retrofit I had ever done, but it's been working for over a year now.
-
http://www.mazakusa.com/productpage.asp?lngEquipID=7
;D