Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ted383 on January 27, 2010, 10:51:49 AM
-
Newb here. I am looking for a Mach3 manual to use with my PlasmaRoute/Thermodyne plasma table. I am using SheetCAM, MP300 DTHC and steppers. Mach is ver R3.042.20. The .pdf's I've seen seam to be for milling and turning.
-ted
.
-
Dont think there is a manual specific to plasma but the mill manuals mention the settings I think. There may be a video but again I am not sure.
Hood
-
Thanks. I looked the mill manual over and saw a couple references to plasma cutting so I took the .pdf to Staples and they printed the 157 pages for $13.
-ted
-
:) sounds like a decent deal
Hood