Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: babinda01 on January 27, 2010, 05:04:00 AM
-
Hi
I am trying to use Mach3 with the KFlop/ KAnalog boards, and I have my motors turning fine as expected, but for the life of me I can't get any of the inputs or outputs working.
I am using V4.19 of the dynomotion plugin. And the latest lock-down version of mach3.
If I hook an input up to Mach3 ie input 1 and I configure this to bit 136 on the kanalog board, I can see the bit change on the kmotion software but on the mach3 end the input 1 led blinks continually whether the switch is made or not. Does anyone have experience with this problem??? Do I need to add anthing special to my initalise script that is run on reset??
Any help would be greatly appreciated.
Regards
Andrew