Machsupport Forum

Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: Vmax on January 12, 2006, 04:06:46 PM

Title: Race Car parts
Post by: Vmax on January 12, 2006, 04:06:46 PM

Pictures of racecar parts built with Mach3/NF. This piece adapts Hendricks swaybar into a Roush mount onto a Yates Chassis. It was built with NF conversational programming.
Inside circle
Outside circle
Outside square
Inside square
Key slots
Drill pattern

No CAD No CAM No Gcode programing
Just went from modual to modual and poof it was done.
Good job Brian keep up the good work.

(:~)= Terry

Title: Re: Race Car parts
Post by: ynneb on January 12, 2006, 04:41:35 PM

Thats a great advertisement for NewFangled.
You did this using a $50 dollar plugun for Mach3 ?
Sound like a fantastic deal.

Title: Re: Race Car parts
Post by: Brian Barker on January 12, 2006, 06:56:35 PM

Very nice to see you using them as I hoped many would! It is cam for the people that make parts :)

I am going to have to get working on my 64 Chevy truck, you guys are having all the fun. ;)

Title: Re: Race Car parts
Post by: Vmax on January 12, 2006, 08:55:48 PM

Another set of adaptors this time Roush Bar to Yates Chassis. Guys this is too easy I better unload that NF stuff before I get Lazy!!!!!!!   NOT.....

Now if I only had that tapping Wizzard to go with it !!!!!!!!!!!!!!!!!!!!!!!

Doing  a Front Motor plate is a lot of drilling and tapping...