Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: M250cnc on January 19, 2010, 07:02:01 AM
-
This is probably my setup but i will ask anyway.
For the last few updates of Mach while i have been moving the model in the toolpath window, i have found that it can completely shut down Mach and go to the desktop ?
Also with the latest versions of the Pokeys also, upon Mach start-up it will say no Pokeys found but the Pokeys is actually working
This is a laptop with a motion control device. ;)
I am just about to start using ver 036 Hood says it for weird computers & i think mine fits the bill. ;D
Phil
-
Never seen that Phil, hope 036 cures your issues.
Hood
-
Hood thanks for your concern.
I am occasionally not seeing the stock model on the screen that seems when it is more likely to happen.
I am now running ver 036 but when i pressed "close file" it did it again.
Are you sure there is nothing in your vast knowledge that could give a clue.
Phil
-
I have just spent the whole day from 8am to 9pm sorting three tax years worth of invoices and afraid my brain is a bit dead, or should I say even more dead than normal.
If I can think of anything I will shout but at this time afraid I cant. Only thing would possibly be your hardware is on its way out, maybe memory problems or graphics issues, try reseating that kind of stuff, it mght help.
Hood