Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: hudmut on January 18, 2010, 05:10:17 PM
-
Can some one tell me if I'm right here. If I'm in ports and pins / outputs and if i set charge pump port 1 and pin 1 that's it charge pump is working.
Then i can remove the jumper from my bob so when i start the PC the vdf want fire up and once mach is up and running i can move my motors.
I'm asking as it just seems to simple there in no LED on in my diagnostic screen ?
-
If your BOB supports the chargepump and if that pin is pin 1 on the BOB.
Hood
-
Your a good man hood all ways there to help
I was just not that use to things being that easy
It makes a nice change
-
LOL, on my BOB I think its pin 17 but I never used the chargepump anyway so not 100% sure