Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: TheLaserShop on January 18, 2010, 03:49:18 PM

Title: Good servo tune in Axis Works is way different in Mach 3 ??
Post by: TheLaserShop on January 18, 2010, 03:49:18 PM
I can get my servo motors tuned pretty good in Axis Works but when I start Mach 3 they act totally different and out of tune. I have checked and double checked everything. I Make sure the velocity and torque is all the same as I used in axis works. I have uploaded the xml file multiple times. My PIDS have to be sky high to operate in Mach 3 verses what was good in Axis Works. I can manually inspect the XML and the settings are what I saved in Axis Works and there isn't a problem. I go back to Axis Works and all runs smooth as is. I just dint know what I'm doing wrong.