Machsupport Forum

Third party software and hardware support forums. => SmoothStepper USB => Topic started by: kree8tiv on January 13, 2010, 06:09:39 PM

Title: Smooth Stepper Causing Different Motion in Slaved Axis
Post by: kree8tiv on January 13, 2010, 06:09:39 PM

Hello,

Currently operating with Y and C Slaved. Distance is different and gantry twists?  Have had similar issues if non-motherboard mounted parallel port used in the past.  Any suggestions?

Have tried noise and decreasing max frequency in Plug in Control to no avail.

Help apprreciated!

Title: Re: Smooth Stepper Causing Different Motion in Slaved Axis
Post by: ger21 on January 13, 2010, 07:06:59 PM

Any time i've seen this problem, it's been because the steps/unit were set differently for the two axis.