Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: najnielkp on September 19, 2006, 08:06:40 PM
-
i have a problem with mach 3 referencing to home. using input pin 11 for x, pin 12 y,pin 13 z. when referencing ,mach 3 hits the limit and the estop trips, does not back off the switch. i hve to switch off motor power and hand crank off the switch. limit overide does not work. the estop wont reset.
tried this setup with mach 2 and works no problem.
-
Do you have the limit set up and not the Home input ?
Thanks
-
solved it. i set the debounce to 500 and now works . thanks Brian.