Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dinko on January 09, 2010, 10:19:30 AM
-
Hello!!
I'm new in this thing..
i bought some 3 axis controler..but i have some problems:
when i test to rotate wint Keys on screen works only on one way :
X works only in -x way
Y works only in -y way
Z works only in -z way
in + ways dont work... why
thanks (& sorry about my language)
greetings from slovenia!!
-
Well, it could be any of the following -
1) Stepper wires hooked up incorrectly. Having one wire loose can cause a motor to only rotate one direction.
2) You 'Direction' pin assignment in 'Ports&Pins' is incorrect.
3) You have the system Hotkeys assigned incorrectly.
-
Another thing could be that your stepper drives can be configured for either Step/Dir or CW/CCW. If that is the case then you may have them set to CW/CCW by mistake.
Hood