Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: NormB on January 07, 2010, 03:58:42 AM
-
I have the tool Hit Indicator and need to understand how to connect this to Mach3. I know it's nothing less or more than a micro switch in a controlled height block with a spring loaded indicator pad. Can this be set up as a Probe in Mach3? Right now it's wired into my controller on Pin 13 so I think it could work like a limit but not to convenient. any information would be appreciated.
-
Yes you will assign it to the Probe input. Do a search for tool height macro or similar as there is loads of info on the macros used.
Hood
-
thank you........I have since done this search and you are right so many it's hard to sort through. I am working on it though.