Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Generic on January 06, 2010, 02:14:59 PM

Title: Post processor for interfacing siemens-NX to Mach3
Post by: Generic on January 06, 2010, 02:14:59 PM
Hello,

I am a new user setting up my first build. It is a revamp of a machine that had a crappy controller and bad wiring.

Everything works great now. I am using a new Campbell designs breakout board with 4 gecko 210 drives.

My problem is that I cant find a post processor from siemens for the Mach3 software. I think that I can get something to work by using a postprocessor designed for fanuc but I haven't had any luck randomly trying them.

Can anyone give me guidance on where to find, or who to talk to about someone who has dealt with this before?

Thanks,

Eric Tarkleson
MSU - Turbomachinery Lab