Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: BarryB on January 01, 2010, 02:38:56 PM
-
Hello, I have all my axis behaving normally, except for my Y axis. When I press the up arrow key, it's moving in the Y minus direction, the down arrow it moves in the Y plus direction. Under homing/limits, I've tried clicking on reversing Y, only this doesn't do anything. With the other axis, it looks like it does reverse them, but not with Y. I'm drawing a blank here. Suggestions?
Barry
-
Restarting Mach3 cleared up that problem. I do have another issue, but I'll save that for a separate e-mail.