Machsupport Forum
Tangent Corner => Polls => Topic started by: Dan13 on January 01, 2010, 02:47:01 AM
-
Hi all,
This poll is related to the product shown in this thread http://www.machsupport.com/forum/index.php/topic,13579.0.html
Comments are welcome.
Thanks,
Daniel
-
I can't change my vote, but I should have selected Nema23 Square and 60mm Square. Keling motors are 60mm - http://www.kelinginc.net/KL23H286-20-8B.pdf
-
Dan,
There is an option to allow viewer to change a vote......if you choose to check the box.
If you can no longer edit the poll, it can be done by admin.
Russ
-
Russ,
Don't see this option when I click the Edit Poll option...
I tried to add a note above, but ran out of space - it there anything can be done?
Thanks,
Daniel
-
OK Dan, I checked this box for you,
Russ
-
Thanks Russ!!
Any way more characters can be added to the question field above, so I complete the note?
Daniel
-
Dosent look like it. Not sure. Make it smaller or we can put your note in your first post below the poll. I did not know there was a limit in the poll itself.
-
OK, made it a bit shorter, but still need 3 more characters. But the message is understandable as it is now, I think.
Daniel
-
I think so too.
Might just check into that, see if it can easily be expanded a bit.
-
I got my votes corrected, Thanks.
btw Daniel, just drop the word "please", OR say
". . . . - NEMA23 frames measure ~ 2.25", but the 60mm frames measure ~ 2.38"
-
HomeShopCNC RS23-570 are also 60mm frames.
http://www.homeshopcnc.com/RSstepperMotors2.html (http://www.homeshopcnc.com/RSstepperMotors2.html)
-
Thanks for the note. We are working on the 60mm frame covers as well. Hope they will be available soon.
Strange or not, according to the poll results 60mm frame are 3 times less popular than 57mm frame...
Daniel
-
Hi All,
It seems to me that people probably believe that they have Nema 23 sized frames but I'm sure that a lot wouldn't realise that they are actually 60mm. Perhaps these chinese stepper motors should be refered to as Nema 24's?. I don't think this poll is going to be entirely accurate. However, I can't wait to get my hands on some 60mm back shells.
-
I'm running Nema 34's, did any get produced?
-
Hi,
Replied your other post here:
http://www.machsupport.com/forum/index.php/topic,13579.msg154624.html#msg154624
Dan