Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ErnieD on December 31, 2009, 12:16:08 PM

Title: Bad character used line 1
Post by: ErnieD on December 31, 2009, 12:16:08 PM

Hi,

  I get the above message and I am not sure what it means. My first line is ( :01933 )

What am I doing wrong?

Thanks,

         ErnieD

Title: Re: Bad character used line 1
Post by: Graham Waterworth on December 31, 2009, 12:21:10 PM

Remove the :

Graham

Title: Re: Bad character used line 1
Post by: ErnieD on December 31, 2009, 12:24:43 PM

Graham,

           Removed the : and still get the same message.

Thanks,

           Ernie

Title: Re: Bad character used line 1
Post by: Graham Waterworth on December 31, 2009, 12:28:34 PM

Ah, so the ( ) are there too, list the first few lines of your program or attach it using the Additional Options.

Graham

Title: Re: Bad character used line 1
Post by: ErnieD on December 31, 2009, 12:57:25 PM

Graham,

        I removed the entire program number and the code ran fine.
Thanks,

         Ernie

Title: Re: Bad character used line 1
Post by: Graham Waterworth on December 31, 2009, 12:58:16 PM

 :)