Machsupport Forum
Mach Discussion => FAQs => Topic started by: phbrown on December 26, 2009, 12:27:30 AM
-
I need to make an ellipse from .125 brass. 1.6 long .800 wide The wizard in Mach3 dosen't work. There is a picture of one in Lazycam, I think it is in Paint I can't do anything with it. Can anybody help me out?
-
Here is a dxf file with your ellipse that you can use in LazyCam.
RICH
-
:)Thanks a lot. Ellipse worked out great even though I forgot to tell you the tool dia. It dosen't matter if it is a bit smaller.
This a wonderfull group. I hope the day comes when I can help some of you.
-
No big deal, glad it worled for you. As far doing anything with it, that's your nickle, but give yel if you need help in LC.
RICH