Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: coyotegd on December 17, 2009, 10:38:23 PM
-
???
I don't know what caused this but pin 1 of the parallel port stopped functioning as my X axis step output. I tried using pin 1 as the direction output instead to no avail. Tried using it with the Y and Z axis, but still no success.
Has anyone had this problem before? I am using all of the output pins, so I can't just change to another pin. I've tried upgrading to 3.45, without success, and given the port driver causing problems with laptops, I went back to version 2.65.
I know the parallel port output is the problem as I have tested the outputs with a digital probe. It is not my breakout board.
Thanks in advance for any suggestions.
Ken Klausner
-
If you can try a normal type output such as coolant on Pin 1 and see if it works, if not then it would seem your parallel port is bad.
Hood