Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tinman13 on September 13, 2006, 01:55:01 AM
-
Not sure how to word this but I'll try......I am using Mach 3 to run a servo driven burning machine and it just started stopping briefly or hesetating after an arc move.
It doesn't stop the program, but pauses for a fraction of a second. At 150 ipm it is quite jerky. I don't remember changing anything........ But being new at this I can't say for sure!
Thanks in advance, Steve
-
Try putting a G64 in the Gcode program
How is it then?
-
Thank You for the reply, I discoverd that I han "No Angular Discrimination" unchecked.
We are happy now! Thanks Steve