Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Pich on December 15, 2009, 12:18:43 PM
-
Does anyone know if there is a way to automatically press the reset button when booting into Mach3?
-
That would be an unsafe way to work. The reset button is in that condition because it is the safest way to power up. Defeating this feature could be dangerous.
-
Yes I understand, my application is not in a machining environment but in robotics
-
I don't see any condition where it is a safe thing, which is most likely why they do not provide a way to disable it.