Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: khalid on December 14, 2009, 12:41:43 PM
-
Reference to following thread at CNCZone
http://www.cnczone.com/forums/showthread.php?t=10369
In the above thread a link is given for Mach3Beta7.61.exe... Can someone help me finding this... I want this Beta version because it has capability of Running all the three axis in harmony of one axis you want to run.
Thanks and appreciation for help.
Best Regards
-
If you are meaning Shuttle mode then it should work in any version of Mach since that Beta version.
Hood
-
Thanks Hood as always you help me... I found it.. :)