Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Tsooko on December 11, 2009, 12:43:23 PM
-
When trying to setup mach 3 I can set the first two pages in the config tab but the motor tuning tab shows nothing when I click on it. What am I doing wrong or is this a glitch in the software? ???
The motors move the gantry and all the axis move when jogging but only very slowly and when I run the roadrunner program it barely moves.
The video shows a mm set up but I used inches. then I set it in mm but still don't get the motor tuning page.
Thanks Ted
-
Try re-installing. Make sure to uninstall and delete the Mach3 folder first.
-
Thanks got it. I ended up downloading the upgrade and transfering the registration. now I need to move it to the computer that runs the machine.
Ted