Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: BarryM on December 10, 2009, 09:32:37 PM
-
Iam very new to cnc Ive just finished inputting some info into mach3 the problem I have is on motor home/soft limits,I put in the size of my table the rev,home neg,auto zero are all checked but when I go back to the main control panel in the window in the upper right hand corner it does not show the table size in either machine coordinates or work off set.
-
Hi Barry,
Toggle the DISPLAY MODE button and you should see the white dotted lines illustrating the extents of your Soft Limits.
RC