Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: alanr on December 06, 2009, 06:28:06 PM
-
I'm just getting started with Mach3 after years of using the DOS based CNCPro.
One thing I like about CNCPro is the ability to do everything with the keyboard. Given the extreme lack of space in the shop, not having to find room for a mouse is a BIG win.
Is it possible to run Mach3 pretty much entirely with the keyboard?
Thanks.
Alan
-
Not really, you could set up loads of hotkeys to do most buttons but things like selecting DROs I dont think you could do without some form of pointing device. I dislike mice on a machine, I do have a trackball on all of them but mainly use a touch screen and external buttons.
Hood
-
How about a small keyboard with a built-in touchpad?
Ron