Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wawatobi on December 06, 2009, 05:43:25 PM
-
I posted this problem quite some time ago and could not find a solution. My machine stops quite often when I use backlash compensation. Then I have to re-index and start the job over again. I run my Taig mill without backlash compensation and get by but there are a lot of jobs I cannot do without backlash compensation. Anybody know if the latest versions have addresses this problem? My version is at least three years old.
R. H.
-
Backlash was very problematic before, especially with steppers. It is reported to work very well now, although I have never used it myself.
Hood
-
Just used my mill with ver 3.042.032, steppers, and backash compensation the other day and all worked well for some simple pockets I was doing.
RICH