Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: geh1 on September 10, 2006, 07:28:06 PM
-
I just added the fourth axis (rotary table) to my system and can't seem to find out how to jog it. I am using the a drive output for the rotary out put.
Thanks for your time! -G-
-
Go to the system hotkeys config and you can set them to whatever you would like. I use home and end for my c and insert delete for my b
Chad
-
Thanks for the reply Chad, I'll give it a try. -G-