Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: willy469 on November 23, 2009, 11:51:56 AM

Title: spindle via modbus
Post by: willy469 on November 23, 2009, 11:51:56 AM

Hi,

I'm new to CNC, and I'm triying to use my spindle via MODBUS.
I have an LG IC5 inverter with modbus RTU,
I can make it work perfectly using DriveView Application (wich comes with the Inverter Modbus Interface)
So the inverter is correctly wired.


I have no idea how to make it work when using Mach3. I Tryed enabling the modBus Spindle on Spindle SetUp, but dón know how to send the correct parameters to the inverter (parameters for frecuency, Forward, Reverse and Stop)

Thank you!

Willy

Title: Re: spindle via modbus
Post by: chrisdu on February 27, 2018, 12:31:54 PM

Hello, I am also looking for an answer to this question.
But I have a Powtran PI9130.
Have found a good video so far.

https://www.youtube.com/watch?v=94hYgp7AsdU&t=1092s

Christian

Title: Re: spindle via modbus
Post by: joeaverage on February 27, 2018, 12:48:05 PM

Hi,
try:

http://www.machsupport.com/forum/index.php/topic,35916.0.html (http://www.machsupport.com/forum/index.php/topic,35916.0.html)

Craig