Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: najnielkp on September 10, 2006, 06:56:00 AM
-
hello all,
i am a new user of mach 3. i have a problem with editing gcode. when i click on the icon , nothing happens. i have to open up with notepad manually. is this function disabled?
-
Go to Config>Logic, and click the browse nutton on the right side and make sure the path points to Notepad. Is this Win2K? I think the path gets messed up in Win2K sometimes.
-
thanks, i wil try it tomorrow.