Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fiend51 on November 18, 2009, 09:26:29 PM
-
hi every one i have a taig cnc mill and a gecko 540 controller and i have a problem trying to run the spindle ...i cant get it to turn on the plug going to the motor is connected to the gecko control er but i don't know how the to get it to run ...i went to mach 3 videos and watch them but i still cant get it to run is there... every thing esle work great i just don't know what i am doing wrong please help if some one had the same problem
-
I'm having a bit of trouble understanding your setup. But to turn the spindle on and off via Mach3 through the G540, you need to have the G540 control a relay that turns the power to the spindle on/off
Once you have set it up you should be able to use the M3/M4 and M5 words to control the spindle from GCode.
Cheers,
Peter.
-
would the the gecko already have the relay in it ????
-
Hi,
Absolutely not. Have a look at the sample setup diagram GeckoDrive manual. It shows you how to control the relay.
http://www.geckodrive.com/upload/G540%20REV4%20MANUAL.pdf
Cheers,
Peter.
-
so were do i buy the relay at and how do i install it