Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: 30t000 on November 13, 2009, 09:36:48 AM
-
Can anyone tell me what they have used succesfully to control the spindle of a boxford tcl125,both driving it and deriving spindle speed etc for threading.
And can anyone tell how the turret operates on the boxford and explain how to drive it through that glorious application known as Mach3.
-
Have a look here :-
http://www.cncdoctor.co.uk/15.html
Graham
-
Thanks for that , but unfortunately I have tried to get them to ring me over the last couple of days because they have no number listed. They are obviously to busy to respond so I was hoping there might be another way.
Thanks again.