Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: guynamedbathgate on September 08, 2006, 08:08:36 PM

Title: I know I read this
Post by: guynamedbathgate on September 08, 2006, 08:08:36 PM

I just cant seem to find it. The main display is oversized on my screen and I cant seem to figure out how to format it properly. Sorry i suck so bad. first one with the answers wins.

Title: Re: I know I read this
Post by: zealous on September 08, 2006, 09:17:07 PM

Under "Config"/"General Config/Auto screen enlarge
Should fix the problem

This might be slightly different depending on which version of Mach you’re using. The developer’s edition (which I have cut out hundreds of parts with no problems) has it located here. I might add that I really like the new organized Mach ;D ;D ;D

Title: Re: I know I read this
Post by: Chip on September 08, 2006, 09:21:20 PM

Hi, guynamedbathgate

May be Config, General Logic,  bottom center, Auto Screen Enlarge, un check it, OK, then restart Mach.

Or is this a Windows screen problem,. Start, Control Panel, Display, Settings, screen resoluation, move bar, Apply, OK.

Second again ------------------so sad

Hope this Helps, Chip