Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chrisjh on November 07, 2009, 05:52:21 PM
-
I have tried to change the G73 Pullback from the default 0.1 (presumably inches) to 1mm ( My units are set to metric) and get to stick at that setting.
I can get it to change from 0.1 to 1 by entering "OK" not "Enter".
Problem is when I reboot Mach3 the pullback reverts to 0.1.
Can this be fixed?
Regards
Chrisjh